Installing A Scsi Hard-Disk Drive; Removing The Front Bezel - Dell PowerEdge 4300 Installation And Troubleshooting Manual

9-2 Dell PowerEdge 4300 Systems Installation and Troubleshooting Guide
This chapter describes how to install the following options in the external drive bays:
Drives that use the computer's integrated diskette drive controller
Drives that use the computer's integrated Ultra/Narrow SCSI controller
Tape drives that use a controller card
Hard-disk drives installed in the optional external drive bay assembly
NOTE: If you are installing a SCSI hard-disk drive in the internal drive bays, see
Chapter 10, "Installing Hard-Disk Drives."
To remove or install drives in the external bays, you must remove the computer cov-
ers and front bezel according to the instructions in "Removing the Computer Cover"
in Chapter 7 .
To protect the inside of the computer from foreign particles, a plastic front-panel
insert covers each empty external drive bay. Before you install a drive in an empty bay,
you must first remove the front-panel insert.
Whenever you remove a drive, be sure to replace the front-panel insert over the
empty bay.
To remove the front-panel insert for a drive bay you intend to use, first remove the
front bezel as instructed in "Removing the Front Bezel" in Chapter 7 . Then, facing the
inside of the front bezel, press against the center of the insert with your thumbs until
the insert bows sufficiently to loosen the tabs on the sides of the insert. Pull the
insert out of the bezel.
To replace a front-panel insert , position the insert over the bay opening from the inside
of the front bezel and carefully press the insert into place. A tab on each side of the
insert snaps into a corresponding latch on the inside of the front bezel.