Dell PowerEdge 4300 Installation And Troubleshooting Manual page 154

9-12 Dell PowerEdge 4300 Systems Installation and Troubleshooting Guide
3. Close the drive carrier handle to lock the drive in place.
4. Repeat steps 1 through 3 to install a second drive in the assembly.
5. Attach the locking bar to the front of the drive bay assembly.
a. Insert the bottom end of the locking bar (the end without the screw hole)
into the slot at the bottom-front of the assembly.
b. Pivot the locking bar up so that the recessed hole at the top of the bar aligns
with the screw hole at the top of the assembly, and secure the locking bar
with the flush-mount screw.
6. Shut down the system, turn off the computer and any attached peripherals, and
disconnect the computer and peripherals from their electrical outlets.Turn off the
system, including any attached peripherals, and disconnect the system from its
electrical outlet.
7 . Remove the computer cover and front bezel.
See "Removing the Computer Cover" and "Removing the Front Bezel" in
Chapter 7 .
8. Remove the metal inserts from the external drive bay.
9. Slide the drive bay assembly into the external drive bay until it snaps securely in
place.
10. Attach the two connectors on the terminator end of the SCSI cable to the two
SCSI connectors on the back of the drive bay assembly, and attach the connector
on the other end of the cable to either the SCSI1 connector on the system board
(see Figure 9-8), or a host adapter card.