SCSI hard-disk
drives in external
drive bay assembly
Ultra2/LVD
SCSI connector
(SCSI1)
11. Attach the power cable(s) to the power connector(s) on the back of the drive bay
assembly.
12. Remove any front-panel inserts on the front bezel that block the external drive
bay.
See "Removing and Replacing Front-Panel Inserts" earlier in this chapter.
13. Replace the front bezel and computer cover.
14. Reconnect the computer and peripherals to their electrical outlets, and turn them on.
15. Install any required SCSI device drivers.
See Chapter 3, "Installing and Configuring SCSI Drivers," in your User's Guide for
information.
16. If the hard-disk drive is a new drive, run the SCSI Devices test group in the Dell
Diagnostics.
See Chapter 5, "Running the Dell Diagnostics," for information.
terminator
Installing Drives in the External Bays
SCSI cable with
terminator
9-13