Dell PowerEdge 4300 Installation And Troubleshooting Manual page 40

3-10 Dell PowerEdge 4300 Systems Installation and Troubleshooting Guide
1-3-2 No memory installed
1-3-3 Chip or data line failure in
the first 64 KB of main
memory
1-3-4 Odd/even logic failure in
the first 64 KB of main
memory
1-4-1 Address line failure in the
first 64 KB of main
memory
1-4-2 Parity failure in the first
64 KB of main memory
2-1-1 Bit failure in the first
through 64 KB of main memory
2-4-4
3-1-1 Slave DMA-register
failure
3-1-2 Master DMA-register
failure
3-1-3 Master interrupt-mask
register failure
3-1-4 Slave interrupt-mask
register failure
3-2-4 Keyboard-controller test
failure
3-3-1 CMOS failure
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviations and
acronyms list that precedes the Index.
Remove and reseat the DIMMs. If the
problem persists, replace the DIMMs. See
"Adding Memory" in Chapter 8 for instruc-
tions on installing or removing DIMMs. If
the problem still persists, replace the sys-
tem board. See Chapter 11, "Getting
Help," for instructions on obtaining techni-
cal assistance.
Replace the system board. See Chapter 11,
"Getting Help," for instructions on obtain-
ing technical assistance.
Check the keyboard cable and connector
for proper connection. If the problem per-
sists, run the Keyboard Test Group in the
Dell Diagnostics to determine whether the
keyboard or keyboard controller is faulty.
See Chapter 5, "Running the Dell Diagnos-
tics."If the keyboard controller is faulty,
replace the system board. See Chapter 11,
"Getting Help," for instructions on obtain-
ing technical assistance.
Run the System Set Test Group in the Dell
Diagnostics to isolate the problem. See
Chapter 5, "Running the Dell Diagnostics."