Dell PowerEdge 4300 Installation And Troubleshooting Manual page 43

Table 3-3 lists some of the alert log messages from the Dell OpenManage HIP
application.
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviations and
acronyms list that precedes the Index.
The server stopped func-
tioning and called the
notification number
specified in the DC
Console Actions tab.
The chassis of an attached
system has been opened.
The system power con-
sumption is exceeding
power supply capacity.
The power supply name is
provided.
The system power con-
sumption is exceeding
power supply capacity.
The power supply name is
provided.
The server will reboot if
the application's Reset or
Power Cycle option was
selected. If neither
option was selected, the
system can be reset
using the Remote Man-
agement feature in the
Dell Remote Assistant
Card utility.
Check to make sure the
system chassis is closed.
Verify that all of the
expansion cards in the
system are functioning
properly. Verify that the
load requirements of the
hardware configured in
the system do not
exceed the capacity of
the power supply or
supplies.
Verify that all of the
expansion cards in the
system are functioning
properly. Verify that the
load requirements of the
hardware configured in
the system does not
exceed the capacity of
the power supply or
supplies.
Messages and Codes 3-13