Dell PowerEdge 4300 Installation And Troubleshooting Manual page 203


PWR1 To POWER1 connector on system board
PWR2 To POWER2 connector on system board
PWR3 Not used
FD To diskette drives and other devices in external drive bays
HD_B/P To POWER connector on SCSI backplane board
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviations and
acronyms list that precedes the Index.
17 . Slide the system board tray back into the chassis.
18. Reinstall the primary power supply.
19. Install the additional power supply or supplies.
20. Connect the AC power cables to the power supply and to the electrical outlet.
Make sure that the AC power cable passes through the plastic strain-relief clips
on the drive latches.
Upgrading the Computer With Additional Power Supplies C-5