Dell PowerEdge 4300 Installation And Troubleshooting Manual page 161

appears, followed by the "drive ready for insertion or removal" pattern. After the
replacement drive is installed, the "drive being prepared for operation" pattern
appears, followed by the "drive online" pattern.
NOTE: If you do not have a Dell PowerEdge Expandable RAID Controller host adapter
card installed, you will see only the "drive online" and "drive bay empty" indicator
patterns.
Identify drive
Drive being prepared for
removal
Drive ready for insertion
or removal
Drive being prepared for
operation
Drive bay empty
Drive predicted failure
Drive failed
Drive rebuilding
Drive online
Install a SCSI hard-disk drive in an internal drive bay as follows:
1. If the system does not have a PowerEdge Expandable RAID Controller installed,
shut down the system.
2. Unlock the hard-disk drive keylock on the front of the computer.
The keylock is located behind the door on the front panel.
3. Open the hard-disk drive carrier handle (see Figure 10-4).
All three drive status indicators blink simultaneously.
The three drive status indicators flash sequentially.
All three drive status indicators are off.
The drive online indicator is on. The drive activity
light may flash briefly.
All three drive status indicators are off.
The drive online indicator is on. The drive failure indi-
cator blinks on briefly each second.
The drive online indicator turns off. The drive failure
indicator blinks off briefly each second.
The drive online indicator blinks rapidly.
The drive online indicator is on.
Installing Hard-Disk Drives 10-5