Dell PowerEdge 4300 Installation And Troubleshooting Manual page 33

NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviations and
acronyms list that precedes the Index.
Faulty diskette, faulty or
improperly connected
diskette/tape drive inter-
face cable, or loose
power cable
Faulty diskette/tape drive
controller (defective sys-
tem board)
Diskette write-protect
feature activated
Diskette missing from or
improperly inserted in
diskette drive
Embedded server man-
agement memory may
be temporarily corrupted
Faulty keyboard control-
ler (defective system
board)
Operating system cor-
rupted or not installed
properly
Incorrect configuration
settings in System Setup
program, improperly
connected hard-disk
drive, faulty hard-disk
drive controller
subsystem (defective
system board), or loose
power cable
Check the diskette/tape drive
interface cable and power
cable connections to the drive.
See Chapter 9, "Installing
Drives in the External Bays."
Replace the diskette-drive
interface cable.
Replace the system board.
See Chapter 11, "Getting
Help," for instructions on
obtaining technical assistance.
Move the write-protect tab on
the diskette.
Reinsert or replace the
diskette.
Shut down the system to clear
the memory, and then restart
the system. If the problem
persists, see Chapter 11,
"Getting Help," for instruc-
tions on obtaining technical
assistance.
Replace the system board.
See Chapter 11, "Getting
Help," for instructions on
obtaining technical assistance.
Reinstall the operating
system.
Check the hard-disk drive
configuration settings in the
System Setup program. See
Chapter 4, "Using the System
Setup Program," in the User's
Guide for instructions. Rein-
stall the hard-disk drive. Check
the interface cable and power
cable connections to the back-
plane board. See Chapter 10,
"Installing Hard-Disk Drives."
Messages and Codes 3-3