Dell PowerEdge 4300 Installation And Troubleshooting Manual page 34

3-4 Dell PowerEdge 4300 Systems Installation and Troubleshooting Guide
DGGUHVV
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviations and
acronyms list that precedes the Index.
Incorrect ISA_CLR
jumper configuration,
incorrect configuration
settings in System Setup
program, or faulty
battery
Incorrect micro-
processor jumper
configuration
System detected and
corrected a resource
conflict when system
resources were allo-
cated using the RCU
Expansion card improp-
erly installed or faulty
Keyboard cable connec-
tor loose or improperly
connected, defective
keyboard, or defective
keyboard/mouse control-
ler (defective system
board)
Defective keyboard/
mouse controller (defec-
tive system board)
Keyboard cable connec-
tor loose or improperly
connected, defective
keyboard, or defective
keyboard/mouse control-
ler (defective system
board)
Remove the plug from the
ISA_CLR jumper. See
Appendix B, "Jumpers and
Connectors," for instructions.
Check the System Setup
configuration settings. See
Chapter 4, "Using the System
Setup Program," in the User's
Guide for instructions. Replace
the battery. See Chapter 8,
"Installing System Board
Options."
Check the microprocessor
speed jumper. See Appendix B,
"Jumpers, Switches, and
Connectors."
No action is required.
Reinstall the expansion cards
(see Chapter 8, "Installing Sys-
tem Board Options"). If the
problem persists, replace the
expansion card.
Check the keyboard cable con-
nection. Replace the keyboard.
If the problem persists,
replace the system board.
See Chapter 11, "Getting
Help," for instructions on
obtaining technical assistance.
Replace the system board.
See Chapter 11, "Getting
Help," for instructions on
obtaining technical assistance.
Check the keyboard cable con-
nection. Replace the keyboard.
If the problem persists,
replace the system board. See
Chapter 11, "Getting Help,"
for instructions on obtaining
technical assistance.