Dell PowerEdge 4300 Installation And Troubleshooting Manual page 36

3-6 Dell PowerEdge 4300 Systems Installation and Troubleshooting Guide
NOTE: For the full name of an abbreviation or acronym used in this table, see the abbreviations and
acronyms list that precedes the Index.
Incorrect configuration
settings in System Setup
program, or no operating
system on hard-disk
drive
Defective system board
Faulty diskette, diskette/
tape drive subsystem, or
hard-disk drive
subsystem
No operating system on
diskette
Additional power sup-
plies are required for
current system
configuration
Additional power sup-
plies are required for
current system
configuration
Additional power sup-
plies are required for
current system
configuration
No microprocessor or
terminator card installed
in one of the
microprocessor
connectors
Check the hard-disk drive con-
figuration settings in the
System Setup program. See
Chapter 4, "Using the System
Setup Program," in the User's
Guide for instructions.
Replace the system board.
See Chapter 11, "Getting
Help," for instructions on
obtaining technical assistance.
Replace the diskette or hard-
disk drive. If the problem
persists, replace the system
board. See Chapter 11, "Get-
ting Help," for instructions on
obtaining technical assistance.
Use a bootable diskette.
Reduce amount of memory in
system, or upgrade the sys-
tem by adding a PSPB and
additional power supplies.
Remove the secondary micro-
processor, or upgrade the
system by adding a PSPB and
additional power supplies.
Remove all but one RAID
cards in the system, or
upgrade the system by adding
a PSPB and additional power
supplies.
Ensure that each microproces-
sor connector has either a
terminator card or a micro-
processor installed. See
Chapter 8, "Installing System
Board Options," for
instructions.