Dell 2355 Mono Laser User Manual page 279

Display message
Email Job is completed
with error :
Pop3
Fax Unit Error
Fax Job is completed with
error
Incompatiable
Fax Job is completed with
error :
Communication Error
Fax Job is completed with
error :
Group not available
Fax Job is completed with
error :
Line Busy
Fax Job is completed with
error :
Line Error
Fax Job is completed with
error :
No Answer
Fax Job is completed with
error :
Memory Full
Fuser Error
Low Heat Error
Over Heat Error
Fuser unit Error
278
Meaning
There is a problem in POP3.
A problem has occurred in the fax unit.
The receiving fax number is classified as junk
fax number.
The machine has a communication problem. Ask the sender to try again.
You have tried to select a group location
number where only a single location number
can be used, such as when adding locations for
a multiple send operation.
The receiving fax machine did not answer or
the line is already engaged.
Your machine cannot connect with the
receiving fax machine or has lost contact
because of a problem with the phone line.
The remote fax machine has not answered
after several redial attempts.
The memory is full.
There is a problem in the fuser unit.
Suggested solutions
Configure the POP3 setting.
Unplug the power cord and plug it back in. If
the problem persists, please call for service.
Change the Junk Fax Setup option.
Use a speed dial number or dial a number
manually
Try again after in a few minutes.
Try again. If the problem persists, wait an
hour or so until the line is clear and then try
again.
OR
Turn the ECM mode on.
Try again. Verify the number to ensure that a
fax can be received.
• Split the transmission into more than one
operation.
• Print received faxes.
• Cancel reserved fax in the Priority Fax
feature.
Unplug the power cord and plug it back in. If
the problem persists, please call for service.