14.13 Remote Control Off; System Control Command Type 1 - Canon VC-C50i/VC-C50iR Programmer's Manual

14.13 Remote Control OFF

Function To inhibited remote control
Command 0080h
Parameter Length
Value
Status None
Reference •To set remote control ON by default during power ON.
•By issuing this command, remote control forbidden flag sets 1 and not
receive key code from remote control
•Not to execute remote control through operation under remote control OFF,
even though remote control through command ON comes out. (See 9.
Function of Remote Control)
Format of Control Code
d0 d1
Header Device Num
FFh 30h
Answer Format
d0 d1
Header Device Num
FEh 30h
Error Flag indicates in 2 figures hexadecimal and returns ASCII code value
Example:
In case of No Error :
In case of Busy :
In case of Parameter Error :
In case of Mode Error :
Condition of Error flag to be set
Busy
Parameter Error •In case of assigned parameter illegal.
Mode Error
1 byte
1h
d2 d3
Command
3Xh 00h
d2 d3
Error Code
3Xh e0
00000000B ⇒ 00h ⇒ 30h 30h
00010000B ⇒ 10h ⇒ 31h 30h
01010000B ⇒ 50h ⇒ 35h 30h
10010000B ⇒ 90h ⇒ 39h 30h
•In case of executing Camera Control command.
•In case of executing Pedestal Control command.
•In case of executing Preset Move command.
•Not in status of Camera ON.
•Not in status of Host Control Mode.

System Control Command Type 1

d4 d5
Parameter
80h 31h
d4 d5
End mark
e1 EFh
⇓
142
d6
End mark
EFh
e0 e1