12.24 Pan/Tilt Start Stop; Pedestal Control Command Type 2; 12.23 Pan/Tilt Stop - Canon VC-C50i/VC-C50iR Programmer's Manual

12.24 Pan/Tilt Start Stop

Function To start or stop the motion of Pan/Tilt.
Command 0060h
Parameter Length
First Value
Second Value
Status None
Reference •First parameter assigns Pan motion, and second parameter assigns Tilt
motion.
Depend on the combination of first and second parameter, the following nine
(9) kind of motion can be assigned.
First Parameter Second Parameter
•The stop motion of Pan (0h) is different from the one of Tilt (0).
See 12.23 Pan/Tilt Stop.
•In case of changing motion status of Pan/Tilt by this command, not necessary
to issue Pan/Tilt Stop command. For example, the status in Pan right start
and Tilt up start can be changed to the status in Pan left start and Tilt down
start.
•Pan/Tilt Speed Assignment command is able to set Pan/Tilt Running
Speed.
•By issuing this command, Pan/Tilt will be simultaneously in action, and flag
of Pan/Tilt in action, is to set 1. When Pan motion stops, flag of Pan in action
clears it zero and When Tilt motion stops, flag of Tilt in action clear it zero.
Note:
After power on, in case of receipt of this command without executing
Pedestal Initialize 1 and Pedestal Initialize 2, mode error is returned and
Pedestal Initialize 2 will be executed.
2 byte
0h~2h
0h~2h
0h 0h
0h 1h
0h 2h
1h 0h
1h 1h
1h 2h
2h 0h
2h 1h
2h 2h

Pedestal Control Command Type 2

Pan/Tilt Motion
: Pan Stop, Tilt Stop
: Pan Stop, Tilt Up Start
: Pan Stop, Tilt Down Start
: Pan Right Start, Tilt Stop
: Pan Right Start, Tilt Up Start
: Pan Right Start, Tilt Down Start
: Pan Left Start, Tilt Stop
: Pan Left Start, Tilt Up Start
: Pan Left Start, Tilt Down Start
49