Handling Rolls; Selecting The Roll As The Paper Source - Canon imagePROGRAF iPF610 User Manual

Large format printer

Hide thumbs Also See for imagePROGRAF iPF610:

Table of Contents

Handling rolls

You can switch between manual and auto paper feed methods by pressing the Feeder Selection button. The

Auto Feed lamp is lit when paper is supplied automatically, and the Paper Tray lamp is lit for sheets.

You must specify the auto paper feed method when using rolls. Press the Feeder Selection button to

activate the Auto Feed lamp (a).

Paper jams may occur if you load paper other than the paper specied in the paper settings for the

media source.

You cannot switch the paper source in the following situations:

If the Message lamp is ashing

Check the message on the Display Screen and take action as necessary. (→P.696)

If the Data lamp is ashing

Select the paper source after printing.

If a printer menu operation is in progress

Select the paper source after the menu operation.

When in the process of loading paper

Finish loading the paper before selecting the paper source.

When in the process of replacing Ink Tanks

Finish replacing the Ink Tanks before selecting the paper source.

If the Top Cover is open

Close the Top Cover before selecting the paper source.

At this point, load the roll. (→P.124)

If any paper is loaded that will not be used, remove it before loading the roll.

120 Handling Paper

Table of Contents