Ip Dhcp Snooping Vlan Information Option Format-Type Circuit-Id String - Cisco 3020 - Catalyst Blade Switch Command Reference Manual

Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands
ip dhcp snooping vlan information option format-type circuit-id
string
Use the ip dhcp snooping vlan information option format-type circuit-id string interface
configuration command on the switch to configure the option-82 circuit-ID suboption. Use the no form
of this command to configure the default circuit-ID suboption.
Syntax Description vlan vlan
stringASCII-string
Defaults
The switch VLAN and the port identifier, in the format vlan-mod-port, is the default circuit ID.
Command Modes Interface configuration
Command History Release
12.2(25)SEF
Usage Guidelines You must globally enable DHCP snooping by using the ip dhcp snooping global configuration
command for any DHCP snooping configuration to take effect.
When the option-82 feature is enabled, the default circuit-ID suboption is the switch VLAN and the port
identifier, in the format vlan-mod-port. This command allows you to configure a string of ASCII
characters to be the circuit ID.
When configuring a large number of circuit IDs on a switch, consider the impact of lengthy character
Note
strings on the NVRAM or flash memory. If the circuit-ID configurations, combined with other data,
exceed the capacity of the NVRAM or the flash memory, an error message appears.
Examples
This example shows how to configure the option-82 circuit-ID suboption:
Switch(config-if)# ip dhcp snooping vlan 250 information option format-type circuit-id
string customerABC-250-0-0
You can verify your settings by entering the show ip dhcp snooping user EXEC command.
OL-8916-01
ip dhcp snooping vlan vlan information option format-type circuit-id string ASCII-string
no ip dhcp snooping vlan vlan information option format-type circuit-id string
Modification
This command was introduced.

ip dhcp snooping vlan information option format-type circuit-id string

Specify the VLAN ID. The range is 1 to 4094.
Specify a circuit ID, using from 3 to 63 ASCII characters (no
spaces).
Cisco Catalyst Blade Switch 3020 for HP Command Reference
2-113