Installing The Controller Cache Module - HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Maintenance And Service Manual

5.
After the battery pack is hooked in position, swing the pack downward, ensuring that the bottom
clip and two pegs line up with the holes in the cache module.
6. Verify that the top hook (1) and bottom clip (2) on the battery pack are securely attached to the
cache module.
7. Repeatstep 4
8.
Install the serviced cache module in the controller as instructed in
module.
NOTE:
The cache is disabled while the batteries are charging and is automatically re-enabled after the batteries
are fully charged.

Installing the controller cache module

1. Slide the cache module into the controller (1), until the side latches are fully engaged (2).
2.
Close the controller cover.
3.
Insert the serviced controller into the chassis as instructed in
1
2
15520
through step 6 to install the second battery pack on the module.
Installing the controller cache
2
1
15515
Installing the controller.
maintenance and service guide
83