Installing The Rewritable Optical Controller Pca - HP 6000 SERIES Hardware Installation Manual

HP Series 6000 Hardware Installation Manual
Installing the Rewritable Optical Controller PCA
Note
In order to install the controller PCA, the device (if any) in slot
2 (the right rear slot), must be temporarily removed, so that the
controller PCA can slide into place.
1. Install the PCA mounting bracket into the chassis with the bracket-to-chassis
screw as shown in Figure 5-3.
2. Slide the controller PCA into the PCA guides in slot 1 (see Figure 5-3 and
Figure 5-4). Ensure that the two holes in the controller PCA near the front
of the mass storage system align with the holes in the mounting bracket
beneath the controller PCA.
3. Install the two bracket-to-PCA screws (see Figure 5-4) through the controller
PCA into the mounting bracket. Do not over-tighten these screws.
After the rewritable optical disk drive is installed, reinstall the device (if any)
that was removed from slot 2 (refer to the note above). Refer to the installation
instructions in the appropriate section of this manual.
Rewritable Optical Disk Drive Installation 5·5