HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Maintenance And Service Manual page 39

Message
10 FIRMWARE FLASH
FAILED
11 CLONING REFUSED
SYSTEM HALTED
12 ONLINE UPGRADE
FLASHING FIRMWARE
13 ONLINE UPGRADE
FLASHING STARTED
14 ONLINE UPGRADE
FLASHING DONE
15 ONLINE UPGRADE
FLASHING FAILED
16 ONLINE UPGRADE
RESTARTING SYSTEM
17 ONLINE UPGRADE
COMPLETE
18 ONLINE UPGRADE
INCOMPLETE
19 ONLINE UPGRADE
REDUNDANCY HALTED
20 INITIALIZING
SCSI SUBSYSTEM
21 SCANNING FOR
SCSI DEVICES
22 INITIALIZING
SCSI DEVICES
Type Description
Error
ROM flash failed.
Error
A firmware mismatch
was detected, message
07 CLONE FIRMWARE?
'<'=NO, '>'=YES was
displayed, and the user
selected < for "No".
Informational An online firmware update
is starting.
Informational An online firmware update
is in progress.
An online firmware update
Informational
has completed.
Error
An online firmware update
has failed.
Informational An online firmware update
is forcing an automatic
restart of the system.
Informational An online firmware update
has completed successfully.
Error
An online firmware
update was successful,
but a subsequent step
failed. In dual-controller
configurations, this may
cause the other to not
update properly.
In dual-controller
Informational
configurations, each
controller restarts at least
once during an online
firmware update. During
these restarts, the system is
not redundant.
Informational The SCSI subsystem is being
initialized as part of the
power-on sequence.
Informational The MSA is scanning for
any attached SCSI devices
as part of the power-on
sequence.
Informational The MSA is initializing all
discovered SCSI devices
as part of the power on
sequence.
Action
Download new firmware
from the HP website and
initiate the firmware update
again.
If the issue persists, contact
HP support.
Firmware on the controllers
must be updated to be the
same.
Download new firmware
from the HP website and
initiate the firmware update
again.
If the issue persists, contact
HP support.
Restart the system.
In dual-controller
configurations, if the
07 CLONE FIRMWARE?
'<'=NO, '>'=YES
message is displayed,
select >.
maintenance and service guide
39