Adjusting Reversing Sensor(S) - Chamberlain CSW200UL Owner's Manual

Adjust the "Reverse Sensor" on the OmniControl™ board. Alarm Sensor does not need to be adjusted except where noted below.
The level of reverse sensitivity depends on the weight of the gate
Sensor is too sensitive
Sensor is not sensitive enough
d c 2 0 0 0 ™ R e v e r s e s e n s o r
The DC2000™ has a separate reverse sensor that will need to be adjusted. The 110Vac
operator power needs to be turned off and the DC2000™ should have the
LED ON to make the adjustment.
A d j u s T I N g R E V E R s I N g s E N s O R ( s )
and the condition of installation.
= if the gate stops in midcycle or reverses by itself.
= if the gate hits an object and does not stop or reverse.
Maximum
Sensitivity
Minimum
Sensitivity
"Charge OK"
32
Maximum
Sensitivity
Minimum
Sensitivity