Installing the riser-card assembly
To install the riser-card assembly, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Make sure that the server and all peripheral devices are turned off, and that the
3. Reinstall the Remote Supervisor Adapter II SlimLine if you removed it.
4. Reinstall any adapters and reconnect any cables you might have removed in
5. Carefully align the riser-card assembly with the retention latches, the guides on
If you have other devices to install, do so now. Otherwise, go to "Completing the
installation" on page 29.
Access holes
on page 9.
power cords and all external cables are disconnected.
other procedures.
the rear of the server, and the riser-card connector on the system board; then,
press down on the assembly. Make sure that the riser-card assembly is fully
seated in the riser-card connector on the system board.
Release tabs
Chapter 2. Installing optional devices
25