Table of Contents
Advertisement
Complete the following steps to remove the riser-card assembly.
1. Read the safety information that begins on page v and"Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Remove the cover (see "Removing the cover" on page 11).
4. Push the two retention latches on the riser-card assembly toward the second
24
IBM System x3655 Type 7985: Installation Guide
Access holes
on page 9.
all external cables.
microprocessor slot; then, grasp the assembly at the rear and side edges and
lift it to remove it from the server. Place the riser-card assembly on a flat,
static-protective surface.
Release tabs
Advertisement
Table of Contents
