Table of Contents
Advertisement
6. Replace the riser card assembly if you removed it to install the adapter (see
7. Perform any configuration tasks that are required for the adapter.
If you have other devices to install, do so now. Otherwise, go to "Completing the
installation" on page 29.
Installing the Remote Supervisor Adapter II SlimLine
The optional Remote Supervisor Adapter II SlimLine is installed on the riser card.
After the Remote Supervisor Adapter II SlimLine is installed, the
systems-management Ethernet port on the rear of the server is active.
Note: Earlier versions of the Remote Supervisor Adapter II SlimLine might not work
in this server. See the ServerProven list at http://www.ibm.com/servers/eserver/
serverproven/compat/us/ for the supported Remote Supervisor Adapter II SlimLine.
For details about installing a Remote Supervisor Adapter II SlimLine, see the
documentation that comes with the adapter. The following illustration shows how to
install the Remote Supervisor Adapter II SlimLine on the riser-card.
Riser card assembly
To install the Remote Supervisor Adapter II SlimLine, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the riser-card assembly (see "Removing the riser-card assembly" on
28
IBM System x3655 Type 7985: Installation Guide
Note: For clarity, the riser-card assembly is shown inverted.
Riser card assembly
"Installing the riser-card assembly" on page 25).
Retainer bracket
on page 9.
external cables.
page 23).
Adapter
Riser card
Remote Supervisor Adapter II SlimLine
Advertisement
Table of Contents
