Configuring Pci Adapters; Configuring Startup Devices; Erasing A Lost Or Forgotten Password (Clearing Cmos) - IBM NetWista A60 Type 6838 User Manual

Configuring PCI adapters

Configuring startup devices

Erasing a lost or forgotten password (clearing CMOS)

32
User Guide
v An X over an icon indicates that the device is disabled. A circled exclamation
point over an icon indicates a resource conflict. If an X or a circled
exclamation point appears over an icon, click Properties to learn more about
the source of the problem.
v If the device is not listed, it might not be physically installed correctly. Make
sure that the option is installed according to instructions, all cables and
connections are secure, and any jumper or switch settings are correct.
v If the device is listed under "Other devices," a required device driver is
either missing or installed incorrectly, or the operating system was not
restarted after the device driver was installed. Restart the computer and
check the device again. If it is still listed under "Other devices," refer to the
documentation that comes with the option, and reinstall the device driver.
Note: For further information, refer to the manual for operating system.
Along with the documentation that comes with your adapter, use the following
information to help with adapter configuration.
PCI adapters generally require no user configuration. The computer and operating
system work together to automatically manage the resources that are required by
each device that is installed in the computer and to assign resources to new
devices in a manner that avoids system conflicts.
When your computer is turned on, it searches for an operating system. The order
in which it searches devices for the operating system is the startup sequence. After
adding new devices to the computer, you might want to change the startup
sequence. You can use the BIOS Setup Utility program to configure startup devices.
For more information, see Access IBM.
This section applies to lost or forgotten passwords. For more information about
lost or forgotten passwords, see Access IBM.
To erase a forgotten password:
1. Turn off the computer and all attached devices.
2. Unplug the power cord.
3. Remove the cover. See "Removing the cover" on page 15.
4. Refer to the system board label inside the computer to locate the CMOS
jumper on the system board.
5. Move the jumper from the standard position (pins 1 and 2) to the
maintenance or configure position (pins 2 and 3).
6. Replace the cover and connect the power cord. See "Replacing the cover and
connecting the cables" on page 29.
7. Once you restart the computer, the BIOS Setup Utility screen is displayed.
8. In the maintenance screen, you can clear CMOS settings.
9. Press Esc.
10. Select Exit from the menu.