Blocking Unwanted Faxes; Duplex Scanning - Sharp B750 - UX B/W Inkjet Facsimile Operation Manual

Blocking Unwanted Faxes

The Anti Junk Fax function blocks
reception of faxes from a fax number
that you specify.
To use this function, enter the fax
number that you want to block. Only
one number can be entered.
FUNCTION
1
Press , then
[ ENTRY MODE] appears
2
Press , then
JUNK #] appears.
3
Press .
4
Press (SET) to store an Anti
Junk number.
(To clear a previously stored
number, press
to Step 6.)
5
Enter the fax number with the
number keys (max. 20 digits).
Note: Enter only numbers; hyphens
and spaces cannot be entered.
START/
MEMORY
6
Press .
STOP
7
Press to exit.
♦
When a fax is blocked (or when a
voice call is blocked if you are using
the Caller ID function), a transaction
report (page 58) will print to inform
you (unless "TRANSACTION LIST"
on page 52 is set to "NEVER
PRINT").
until
.
until [ ANTI
(CLEAR) and go
Blocking Unwanted Faxes

Duplex Scanning

Duplex Scanning is convenient for
transmitting or copying two-sided
documents. When this function is
selected, you simply feed all pages of
the document through the machine
once, turn the stack of pages over, and
feed the stack through again. The
machine will automatically sort the
pages into the correct order (front of 1st
page, back of 1st page, front of 2nd
page, back of 2nd page, etc.).
♦
Note that any blank sides must be
included when scanning the pages (if
the number of pages is not equal each
time the machine scans the stack, an
error will result).
1
Load the documents. Make sure the
pages are placed front-side down,
with the first page on the bottom.
•
If desired, press
resolution and/or contrast.
2
Press
2-SIDED SEND
3
Perform all steps of the desired copy
or transmission operation.
4
When all pages of the document
have been scanned, turn the stack
over (do not change the page order)
and load the stack again.
START/
MEMORY
5
Press .
RESOLUTION
to set the
START/
MEMORY
and then .
47