6. Special Functions
Broadcasting
You can send the same document to as
many as 20 locations in just one
operation.
♦
Only destinations stored in Rapid
Keys and Speed Dial numbers can be
selected. (It is not possible to enter a
full fax number.)
1
Load the document(s).
•
If desired, press
resolution and/or contrast.
2
Press
.
BROADCAST
3
Select a destination using one of
the following methods:
•
Press a Rapid Key.
•
SPEED DIAL
Press
and enter a 2-digit
Speed Dial number.
•
Press
or
desired destination appears in the
display.
4
Press
to enter the
destination.
5
Repeat Steps 3 and 4 for each of
the other desired destinations
(maximum of 20).
•
You can press
through and check your entered
RESOLUTION
to set the
until the
to scroll
destinations. To delete a
destination, press
appears.
7
When you have finished selecting
destinations, press
•
Transmission will begin.
•
A Transaction Report is
automatically printed out after
Broadcasting is completed. If any
destinations in the "Note" column of
the report are marked "Busy" or
have a communication error code,
you will need to send the document
to those destinations again.
If the memory becomes full...
If the memory becomes full during
scanning, [MEMORY FULL] will
appear in the display.
START/
♦
MEMORY
Press
to send the pages
which have been stored up to that
point in memory (the remaining
pages will automatically feed out).
After transmission, the memory will
be cleared and you can send the
remaining pages. You will also need
to send the page which was being
scanned when the memory filled
up.
♦
To cancel the entire transmission,
STOP
press
.
Broadcasting
STOP
when it
START/
MEMORY
.
43