Ipv6 Routing - Draytek Vigor2130 Series User Manual

Destination Subnet
Source Start Port
Source End Port (optional)
Destination Start Port
Destination End Port (optional) Type a value as the destination end port. Such value will be
Action
3 . 8 . 4 I P v 6 R o
3 . 8 . 4 I P v 6 R o
This page displays the routing table for the protocol of IPv6.
Device
Prefix
Metric
Expires
MTU
Advmss
Vigor2130 Series User's Guide
u t i n g
u t i n g
Type the subnet mask here if you choose Subnet as
Destination IP Type.
Type a value as the source start port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the source end port. Such value will be
available only TCP/UDP is selected as the protocol.
Type a value as the destination start port. Such value will
be available only TCP/UDP is selected as the protocol.
available only TCP/UDP is selected as the protocol.
Set the action that the router will perform for the packets
through the protocol of IPv6.
Accept – If the IPv6 packets fit the condition listed in this
page, the router will let it pass through.
Drop - If the IPv6 packets fit the condition listed in this
page, the router will block it.
interface name (eth0, eth1, fp, etc..)that
Display the
used to transfer packets with addresses matching the
prefix.
The IPv6 address prefix.
distance to the target (usually counted in
Display the
hops). It is not used by recent kernels, but may be
needed by routing daemons.
Display the lifetime of the route.
he largest size (in bytes) of a packet.
Display t
he largest size (in bytes) of an unfragmented
Display t
piece of a routing advertisement.
93