Maintenance Procedures - MOTO GUZZI V 11 SPORT Workshop Manual

A
B
C
D
E
F
G
H
I
L
M
N
10W
O
15W-40 15W-50
P
10W-40
10W-30
-10
4
A
B
20W
30W
20W-40 20W-50
0 10 20
2

MAINTENANCE PROCEDURES

The various maintenance procedures are described below.
E
NGINE OIL REPLACEMENT
A good engine oil has special qualities.
Only use highly detergent engine oil whose container
certifies that its quality corresponds to, or is higher than,
SE,SF or SG operating requirements.
V
ISCOSITY
The other viscosity levels indicated in the table can be
used if the average temperature of the motorbike's area
of use is within the range indicated on the table.
After the first 300/1000 mi and after about 6000 mi, replace
the oil.
Replacement should be carried out when the engine is
warm to allow the oil to drain more quickly and thoroughly.
To bring the engine up to the standard temperature, please
see section C, chapter 3 in this manual.
Position a suitable pan under the oil sump to collect the
used oil, then replace it following the below procedures:
• Unscrew the oil filler cap with dipstick "A";
• Unscrew the oil-draining plug "B";
• Drain all the used oil in the sump;
• Screw down the oil-draining plug once again and tighten
it to the torque prescribed in the table, section B,
chapter 4 of this manual;
• Pour in the quantity of new engine oil indicated in
chapter 2, section B in this manual through the special
hole;
• Refit the oil filler cap with dipstick in the special seat
and bring it flush.
40W
30 40 ˚C
S M
CHEDULED AINTENANCE