MOTO GUZZI V 11 SPORT Workshop Manual page 140

A
B
A
C
D
E
F
G
1ST DISK SERIES UP TO CHASSIS NO. KR 113 727
H
1. SCHEIBE SERIE BIS RAHMEN NR. KR 113 727
SCHIJF 1° SERIE TOT AAN CHASSIS N. KR 113 727
I
L
M
N
O
P
20
B
RAKE DISKS
Disassembly:
• Remove the brake calipers as described in this chapter;
• Remove the wheel from the motorbike as described in
chapter 1 of this section;
• Unscrew the fastening screws "A" and remove the disk;
Check:
The disks must be perfectly clean, without rust, oil, grease
or deposits and they must not have deep groovings. If the
disks have one of these defects, clean thoroughly. If the
defect cannot be removed they must be replaced.
• Front disk thickness: 4,1 mm.
• Front disk thickness, wear limit: 3,9 mm.
If the disk values are out of the above indicated
measurements, it is necessary to replace them.
The front disks are composed of one part which is integral
to the wheel rim and of a floating brake band.
If the disk must be replaced, it is necessary to replace
both components.
W
HEEL PARTS