Fan Motor Removal; Figure 3-24. Fan Motor Removal - Epson EPL-N1200 Service Manual

Disassembly and Assembly

3.2.2.11 Fan Motor Removal

1. 1. Open the top cover. Remove the imaging cartridge. Cover the imaging cartridge to protect it
from light or place it in a dark area.
2. Remove the main controller board. (Refer to Section 3.2.1.1.)
3. 3. Loosen two CC (M3x6) screws which secure the right cover.
4. Remove left and right tabs of the top cover from the printer base unit then remove the top
cover.
5. Remove one CC (M3x6) screw on the fusing unit cover and remove the fusing unit cover.
6. Disconnect connector for the paper exit sensor then lay the rear panel unit flat.
7. Disconnect connector for the fan motor.
8. Remove two CCB(M3x8) screws then remove the fan motor.
3-20

Figure 3-24. Fan Motor Removal

EPL-N1200 Service Manual
Rev. A