Electrical Specifications; Reliability Specifications; Environmental Conditions For Operating (Including Imaging Cartridge); Environmental Condifitons For Storage And Transporation - Epson EPL-N1200 Service Manual

EPL-N1200 Service Manual

1.2.2 Electrical Specifications

Description
Rated voltage
Rated frequency range
Input frequency range
Power consumption
Power consumption in
non-standby mode
Power consumption in
standby mode
(Heater lamp is off.)

1.2.3 Reliability Specifications

MPBF (Mean Prints Between Failures): Over 50,000 sheets
Note: MPBF indicates average number of pages printed before an occurrence of a problem
requiring replacement or service.
MTBF (Mean Time Between Failures):
Jam rate:
Feed failure:
Multiple-sheet feeding:
Paper curl height:
Leading edge bending (1 cm or more):
MTTR (Mean Time To Repair):
Durability:

1.2.4 Environmental Conditions for Operating (Including Imaging Cartridge)

Temperature:
Humidity:
Altitude:
Levelness:
Illuminance:
Surrounding space:
1.2.5 Environmental Conditions for Storage and Transportation
(Excluding Imaging Cartridge)
Temperature:
Humidity:
Drop test:
Vibration:
Resistance to atmospheric pressure:
Storage period:
Rev. A

Table 1-5. Electrical Specifications

100 V Version
100 ∼ 120 VAC
Less than 700 W
Less than 150 W (Average)
(without any optionals installed)
3000 Power on hours (more than 10 months)
1 out of 2,000 sheets or less (excluding multiple-sheet feeding)
1 out of 2,000 sheets or less (excluding multiple-sheet feeding)
1 out of 500 sheets or less
30 mm (1.2 inches) or less (Standard paper)
30 mm (1.2 inches) or less (OHP sheet)
1 out of 1,000 sheets
30 minutes or less
5 years or 300,000 sheets
10 to 35 ° C (50 to 95 ° F)
15 to 85% RH
2,500m (8,200 feet) or lower
1 degree or less (front to rear,right to left)
3,000 lux or less (must not be exposed to direct sunlight)
Printer should have at least 100mm of clearance on sides
and rear.
0 t o 3 5 ° C (32 to 95 ° F) overfull storage period
30 to 85% RH overfull storage period
Clear to JISZ0200-1987 Level1
Vibration frequency 5 to 100Hz and 100 to 5Hz
Sweep time10 minutes
Acceleration1G
Acceleration direction 3 directions
Acceleration time180 minutes(60 minutes for ach
direction X, Y, Z)
61.3 to 101.3 KPa
18 months (after date of manufacture)
General Description
230 V Version
230 VAC
50 ∼ 60 Hz
47 ∼ 63 Hz
Less than 800 W
Less than 30 W
1-5