EPL-N1200 Service Manual
3.2.1.2 Control Panel Removal
1.
Open the top cover. Remove the imaging cartridge. Cover the imaging cartridge to protect it
from light or place it in a dark area.
2.
Remove the main controller board. (Refer to Section 3.2.1.1.)
3. 3.
Remove one CC (M3x6) screw from the control panel and lift the panel forward.
4.
Remove two CC (M3x8) screws and take the right cover away.
5.
Remove two CC (M3x8) screws on the paper guide case.
6.
Remove four CC (M3x6) screws on the top and two CC (M3x6) screws at the right of the shield
cover and take it away.
7.
Remove connector CN3 on the engine controller board.
8.
Remove the control panel.
Rev. A
Figure 3-3. Control Panel Removal
Figure 3-4. Shield Cover Removal
Disassembly and Assembly
3-5