Fan Motor (M3) Removal; Fusing Unit Removal - Epson EPL-5000 Service Manual

3.2.3.8 Fan Motor
top
from the light or place it in a dark area.
2. Remove the control panel. (Refer to Section
3. Remove the paper cover.
4. Remove the right cover and left cover. (Refer to Section 3.2.2.)
5. Remove the top cover.
6. Remove the rear frame. (Refer to Section 3.2.2.2.)
7. Remove 2 screws

3.2.3.9 Fusing Unit Removal

1. top cover. Remove the imaging cartridge. Cover the imaging cartridge to protect it
Open
the
from the light or place it in a dark area.
2. Remove the control panel. (Refer to Section
Remove the paper cover.
3.
Remove the right cover and left cover. (Refer
Remove the upper unit.
5.
Remove the rear frame. (Refer to Section 3.2.2.2.)
6.
7. the connector for the thermistor in the fusing unit, the comector for the paper exit
sensor, and CN4 on the power supply board
Remove 2 screws
8.
Rev.
Laser Service Manual
Removal
Remove the imaging cartridge. Cover the imaging cartridge to protect it
8), and remove the fan motor
8)
X
Figure 3-17. Removing the Fan
6) on the fusing unit, and remove the fusing unit.
x
6)
Figure 3-18. Removing the Fusing Unit
Motor
Section 3.2.2.)
X
3-15