Troubleshooting
Table 5-12. The LCD Displays Mem Overflow
Cause
The optional SIMM may be
bad.
Standard RAM may be bad.
Table 5-13. The LCD Displays SERVICE REQ. E0003
Cause
The connector for the
thermistor may be
disconnected.
The engine controller board
may be dead.
The heater lamp or thermal
fuse in fusing unit may be
bad.
The power supply board
may be dead.
5-6
Step
Checkpoint
Is operation OK after you
1
remove the optional SIMM?
2
—
Step
Checkpoint
Is the connector for the
1
thermistor disconnected?
Does the heater lamp
2
remain lit up until an error
occurs?
Does the heater lamp come
3
on at power on?
4
—
EPL-N1200 Service Manual
Finding
Solution
Yes
Replace the SIMM.
Replace the C205
—
MAIN board.
Finding
Solution
Yes
Connect it.
Replace the
Yes
engine controller
board.
Replace the heater
No
lamp or thermal
fuse in fusing unit.
Replace the power
—
supply board.
Rev. A