ACT ACTPRO 4000 Operating And Installation Instructions page 40

A B 0V A B 0V
SERIAL/PRINTER
ACTpro 4000
Click here to Connect
ACTWin pro Serial Configuration
For cable information
please see page 44
DOORS
A
B
0V
RX
TX
0V
From the Installer Menu on the keypad,
do the following:
1. Factory Default the controller.
2. For more than one controller an RS-485 network interface is required. Each
controller must be set to a unique address, starting at 1.
3. Connect the controller(s) to the PC.
4. From ACTWin pro, configure a new database.
5. Follow the database creation wizard.
6. Ensure that Comms is set up correctly.
7. Connect to the controllers.
Select Serial Port
Direct Connect Cable
ACTWin pro
36
Click here to configure Comms
Select if Direct Connect or
Networked
Select COM port and Speed