Site Code 2 - ACT ACTPRO 4000 Operating And Installation Instructions

ACTpro 4000 Operating Instructions
__________________________________________________________________________
MAC Address
The MAC Address is a unique 48 bit number that identifies the ACTpro 4000 hardware on
the LAN. This Address is fixed at the Factory.
NetBIOS Name
The NetBIOS name is a unique name that identifies the ACTpro 4000 hardware on the LAN.
This name is fixed at the Factory and should be used to identify the controller in ACTWin
when in DHCP mode.
The Central/Sat menu option allows the ACTpro4000 to be configured as a Central Server for
other ACTpro4000 or ACTpro3000 units (called Satellites) on a TCP/IP network, or as a
Satellite. Changes which occur on a Satellite are reported to the Central Server and are then
sent on to the other Satellites on the network. This allows antipassback to operate over
multiple controllers.
Central Server
Enable or disable the ACTpro4000 as the Central Server. Only ONE Central Server may exist
on a site. In ACTWin pro, the Central Server is called the Cluster Master Controller.
Central IP Addr
If the ACTpro 4000 is a Satellite, enter the IP address of the Central Server here. The Central
Server and Satellites must all use fixed IP addresses.
The card setup menu is used to inform the controller which cards should be recognized by
the system. Usually all that is required is to set the primary site code for the system. The site
code is supplied along with any cards ordered, or can be obtained directly from ACT. In
addition, a site code from another installation may be entered allowing shared access to the
building. Where non-standard cards are being used, possibly from a previous access control
or time & attendance system, the card format may be altered to accept these.
Site Code 1
This function allows the 8-digit site primary code for the system to be entered. The controller
will recognize only cards with a matching site code. This code should also be quoted
whenever additional cards or tags are being ordered for this installation. The factory default
site-code is 10-2770-09, which allows the use of the test card supplied with the controller.

Site Code 2

This function allows an 8-digit site secondary code for the system to be entered. In addition to
the cards containing the primary site code, the controller will also recognize cards with this
site code. In this case, an offset may also be specified – this is a value that is added to the
__________________________________________________________________________________
Central/Sat
Card Setup
28
1.00