ACTpro 4000 Operating Instructions
__________________________________________________________________________
Network Mask
Default Gateway
MAC Address
NetBIOS Name
Network Speed
Central/Sat
Central Server
Central IP Addr
Card Setup
Diagnostics
Voltage Check
Change the PIN used to access the Installer menu.
Change PIN
Factory Defaults
Restore the system to its factory default settings.
*
First it is required to select a door.
Exit from menu is automatic if no keys are pressed for a period of time.
__________________________________________________________________________________
Sets the Network Mask.
Set the default gateway (also known as default route).
Displays the MAC address.
Displays the NetBIOS name.
Set the ACTpro 4000 IP network speed.
Enable DHCP
Enable DHCP operation.
Enable/Disable ACTpro 4000 as Central Server.
Set the IP address of the Central Server.
Site Code 1
Enter the primary site code for the system.
Site Code2
Enter a secondary site code for the system.
Card Format
Enter a custom card format for the system.
Displays the current software version.
Version
Reader test
Reads a card and displays the received information.
Display voltage supplied to ACTpro 4000.
Factory Diag
For Factory Use only. – Do not use.
Last Reset
Displays a code indicating the reason for the last reset.
19
1.00