Smoke Detectors - Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste - LYNXRPK-2 - Wireless Self-Contained Security System Installation And Setup Manual

C o n t r o l
SYMPTOM
1. The word "AC" is not
displayed.
2. Digital communicator
message not being
received.
3. Does not arm
properly.
READY light not on.
4. System doesn't
respond to keystrokes
on keypad.
4a. "CC" displayed.
4b. "dI" displayed.

Smoke Detectors

SYMPTOM
1. Detector alarms, no
apparent reason.
2. Detector's siren
sounds.
POSSIBLE CAUSE
1a. Interrupted AC power supply.
2a. System in Test mode.
2b. Telephone connection not secure.
2c. Digital communicator malfunctioning.
2d. Telephone number in program needs
prefix or access code.
2e. Telephone call to central monitoring
station requires operator assistance.
Open or faulted zone(s)
4a. System is in communication with
downloader at central station.
4b. System has just been powered and is in
its one minute initialization.
POSSIBLE CAUSE
1a. Dust, dirt in sensing chamber.
1b. Improper location.
1c. Unit malfunctioning.
2a. Unit not receiving required power.
2b. Unit malfunctioning.
LYNXR-2 Series Installation and Setup Guide
Troubleshooting Guide
1a. Check transformer connection and
powerline circuit breaker.
2a. Remove from Test mode.
2b. Check all connections.
2c. Check with a different CONTROL PANEL.
2d. Program prefix or access code into the
CONTROL PANEL.
2e. System cannot work in this situation.
Check for faulted zones and make intact, or use
Bypass arming, if desired.
4a. Wait until download session is finished.
4b. Wait for initialization to finish, or bypass
this time by pressing '#' + '0.'
1a. Clean unit's sensing chamber with vacuum
cleaner per unit's instructions.
1b. See unit's instructions for locations to avoid.
Relocate as necessary.
1c. Replace detector.
2a. Check for proper installation of battery. Try new
battery.
2b. Replace detector.
- 67 -
REMEDY
REMEDY