Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste - LYNXRPK-2 - Wireless Self-Contained Security System Installation And Setup Manual page 8

LYNXR-2 Series Installation and Setup Guide
Wiring Connections
Do not remove the local sounder shorting jumper (shunt).
UL UL
UL UL
External sounders and powerline carrier devices have not been evaluated by UL
LOCAL SOUNDER DISABLE: The Master Keypad's built-in piezo sounder can be disabled by removing the
shorting jumper (shunt) on the terminal board. If disabled, however, no sounding will occur upon AC loss,
since the external sounder does not operate when AC power is lost.
3. Make External Sounder Connections - The control panel supports either a 6-14VDC piezo sounder (30mA max.) or
6-14VDC bell (120mA max.; e.g. ADEMCO WAVE2EX).
a. Connect a piezo sounder to terminals 10 (+) and 11 (–); OR a bell to terminals 11 (–) and 12 (+).
4. Disable Local Sounder Option - If required the Master Keypad's built-in piezo sounder can be disabled.
a. Remove the shorting jumper (shunt) on the terminal board.
5. Make Powerline Carrier Device Connections - The control panel supports up to 8 Powerline Carrier Devices. If using
these devices, they must be connected to the K10145X10 transformer, as shown in the SUMMARY OF
CONNECTIONS diagram.
a. Connect the com/data/sync/ lines from the transformer to terminals 9, 13, and 14, respectively.
If not using the supplied connection cable, you may need to reverse the black and yellow wire connections.
Refer to the ✻ ✻ ✻ ✻ 80 Device Programming Menu Mode section for details on programming Powerline Carrier
Devices.
RED
4 5
3 6
RJ31X
2 7
1 8
GREY
DIRECT
CONNECT
CORD
OR
OR
8-POSITION
JACK
TIP RING TIP RING
INCOMING TO
PHONE LINE PREMISES
PHONES
Full Line Seizure Connections
INCOMING
PHONE LINE
RING
TIP
GREEN
TO
PREMISES PHONES
RING
TIP
BROWN
01000-008-V0
- 8 -