Record Custom Voice Descriptors - Honeywell LYNXRPK-2 - Wireless Self-Contained Security Syste - LYNXRPK-2 - Wireless Self-Contained Security System Installation And Setup Manual

LYNXR-2 Series Installation and Setup Guide
✻ 85 Record Custom Voice Descriptors
Use this mode to record up to 5 custom voice descriptors. To enter this mode, enter
Programming mode.
Note: Entering a number other than one specified will give unpredictable results.
85
Assign Custom Voice Descriptors
0 = exit mode
1 = enter mode
d
A 7
Custom Descriptor Number
0 = exit mode
1 = enter mode
Enter 7 + d + [✻]
Note: d = 0-4, each representing custom word 70, 71,
72, 73, or 74, respectively. Any existing word will
be announced.
Press [#] to start recorder. Begin speaking
immediately after the third beep.
Speak the desired word clearly near the microphone.
Recording stops after 1.5 seconds.
6 = accept word and ready to record next descriptor
prompt (A....7d)
[#] = re-record descriptor
00 = exit Record mode after pressing 6 to accept word
Press any key to repeat the recorded word.
Entering "1" advances to the next prompt below.
Entering "0" exits mode, upon which this prompt blinks, indicating the mode
is inactive.
Record up to 5 custom words.
- 52 -
✻ 85 while in