Intel SBXD132 - Server Compute Blade Installation And User Manual page 67

— System MAC Addresses
•
Date and Time
Select this choice to set the system date and time, in 24-hour format
(hour:minute:second).
•
System Security
Select this choice to set a power-on password. See
more information about passwords.
•
Start Options
Select this choice to view or change the start options. Changes in the start options take
effect when you start the blade server.
— Startup Sequence Options
Note: To set the startup sequence, which is the order in which the blade server
You can set keyboard operating characteristics, such as whether the blade server starts
with the keyboard number lock on or off. You can enable the blade server to run
without a diskette drive or keyboard.
You can enable or disable the PXE option for either of the integrated Gigabit Ethernet
controllers. The default setting is Planar Ethernet 1, which enables the PXE option
for the first Ethernet controller on the system board.
If you enable the boot fail count, the BIOS default settings will be restored after three
consecutive failures to find a boot record.
You can enable a virus-detection test that checks for changes in the boot record when
the blade server starts.
This choice is on the full Configuration/Setup menu only.
•
Advanced Setup
Select this choice to change settings for advanced hardware features.
Important: The blade server might malfunction if these options are incorrectly
— Memory Settings
Intel® Server Compute Blade SBXD132 Installation and User's Guide
Select this choice to set and view the MAC addresses for the Ethernet controllers
on the blade server.
Select this choice to view the startup device sequence that is set for the blade
server.
checks devices to find a boot record, you must use the management-module
Web interface.
configured. Follow the instructions on the screen carefully.
Select this choice to manually enable a pair of memory connectors.
If a memory error is detected during POST or memory configuration, the blade
server automatically disables the failing memory pair of memory connectors and
continues operating with reduced memory. After the problem is corrected, you
must enable the memory connectors. Use the arrow keys to highlight the pair of
memory connectors that you want to enable, and use the arrow keys to select
Enable.
"Using Passwords" on page 61 for
59