Intel SBXD132 - Server Compute Blade Installation And User Manual page 34

7. Remove the two screws that secure the heat-sink filler and then remove the filler from
the microprocessor socket.
Install the microprocessor:
Caution:
a. Remove the protective cover from the microprocessor retainer, if one is present.
Caution:
b. Rotate the locking lever on the microprocessor socket from its closed and locked
position until it stops in the fully open position (approximately a 135° angle), as
shown.
c. Rotate the microprocessor retainer on the microprocessor socket from its closed
position until it stops in the fully open position (approximately a 135° angle), as
shown.
d. Touch the static-protective package that contains the new microprocessor to any
unpainted metal surface on the blade server or any unpainted metal surface on any
other grounded rack component in the rack you are installing the microprocessor
in for at least 2 seconds; then, remove the microprocessor from the package.
e. Remove the cover from the bottom of the microprocessor.
26
Do not touch the pins in the microprocessor socket. Touching these pins
might result in permanent damage to the system board.
Microprocessor
dust cover
Do not use any tools or sharp objects to lift the locking lever on the
microprocessor socket. Doing so might result in permanent damage to the
system board.
Microprocessor
Intel® Server Compute Blade SBXD132 Installation and User's Guide
Microprocessor
release lever
Alignment marks
Microprocessor
socket