Table of Contents
Advertisement
Warnings and Cautions
Read and adhere to all warnings, cautions, and notes in this guide and the documents supplied with
the chassis, power supply, baseboard, and accessories. If the instructions for the chassis, base
board, and power supply are inconsistent with these instructions or the instructions for accessories,
contact the supplier to find out how you can ensure that the server meets safety and regulatory
requirements.
WARNINGS
This guide is intended for qualified technical personnel with experience
installing and configuring servers.
SYSTEM POWER ON/OFF: The Power button on the server front
panel DOES NOT remove AC power to the server system. Some
circuitry in the server may continue to operate even though the front
panel Power button is off. Always disconnect the power cord from the
AC power source or wall outlet before performing any of the procedures
in this guide. Failure to do so can result in personal injury or
equipment damage.
HAZARDOUS CONDITIONS, POWER SUPPLY: Hazardous voltage,
current, and energy levels are present inside the power supply. There
are no user-serviceable parts inside the power supply; servicing should
be done by technically qualified personnel.
HAZARDOUS CONDITIONS, DEVICES, AND CABLES: Hazardous
electrical conditions may be present on power, telephone, and
communication cables. Press the Power button to turn off the server
and disconnect the power cord from the AC power source,
telecommunications systems, networks, and modems attached to the
server before removing the cover. Otherwise, personal injury or
equipment damage can result.
CAUTIONS
ELECTROSTATIC DISCHARGE (ESD) AND ESD PROTECTION:
Perform the procedures in this chapter only at an electrostatic discharge
(ESD) workstation since the server components can be extremely sensitive
to ESD. If no such station is available, you can reduce the risk of
electrostatic discharge ESD damage by doing the following:
Wear an anti-static wrist strap and attach it to a metal part of the server.
Touch the metal on the server chassis before touching the server
components.
Keep part of your body in contact with the metal server chassis to dissipate
the static charge while handling the components.
Avoid moving around unnecessarily.
Hold the server components (especially boards) only by the edges.
6 Quick Start Guide
Advertisement
Table of Contents
