Table of Contents
Advertisement
UNIVERGE SV8100
P
S
2
ROGRAMMING
ECTION
From Multiline Terminals
Programming is done using DTH/DTR-8D-1 TEL, DTH/DTR-16D-1 TEL, DTH/
DTR-32D-1 TEL, or DTL-6/12/24/32D-1 TEL, DTL-8LD-1 TEL, ITL-6DE-1 TEL,
ITL-12/24/32D-1 TEL, ITL-8LD-1 TEL, or ITL-320C-1 TEL multiline terminals.
When a programming multiline terminal is off-line in the Program Mode, the rest of the
system continues to function. Most program changes can be entered anytime, but
some changes take effect only when the affected stations and circuits are idle. This
avoids disrupting calls in progress.
PC Programming
System data can be transferred to/from a disk for backup. The System Program End
User software allows end users to program several features for their multiline
terminals, such as: Line Key Assignment, Telephone Names, Zone Paging Groups, or
various timers.
Battery Backup
The battery on the CD-CP00-US retains the Clock/Calendar and Last Number Redial
(LNR) buffers for each station when the CD-CP00-US encounters a power loss.
When the battery is fully charged, the settings are retained for approximately three
years. The Lithium (CR2032) battery should be replaced every two years. The system
programmed memory (Customer Database) is stored in nonvolatile Memory and can
be erased only by a First Initialization.
The batteries, located in the SV8100 chassis, support system operation for up to 30
minutes during a power outage.
User Programmable Features
Multiline terminal users can program the following features from their station:
Multiline terminals without programmable One-Touch keys and single line telephones
can be used to program Station Speed Dial memories. Attendant Positions can be
used to program System Speed Dial memories and the System Clock/Calendar.
General Description Manual
Ringing Line Preference
Feature Access and/or One-Touch keys (e.g., Speed Dial or Direct Station
Selection)
Speed Dial
Issue 5.0
4 - 3
Advertisement
Table of Contents
