Figure 5-4 Connecting The Dlc Using Twisted 2-Pair Cable; Table 5-14 Dt300 Series Loop Resistance And Cable Length; Table 5-15 Dt700 Series Loop Resistance And Cable Length; Table 5-17 Cable Connection Between The Analog Port And The Single Line Equipment - NEC DTL-12BT-1 - DT330 - Plus BCH Description

UNIVERGE SV8100
C
S 4
ABLING
ECTION
This section provides cabling requirements and specifications for various equipment
used in the SV8100 system.
Only the DT300/DT700, D
telephones and wireless telephones discussed in the document can be installed on
the SV8100 system.

Figure 5-4 Connecting the DLC Using Twisted 2-Pair Cable

chassis connected with each of the multiline terminals and single line telephones by a
separate twisted 1-pair cable or 2-pair cable (only for multiline terminals).
Refer to the following tables for cabling requirements and specifications:





General Description Manual
R
EQUIREMENTS AND
term
To avoid damage to equipment, do not install the
term
D
DTP) terminal uses -24V and has no protection from
the -48V power supply used by the SV8100 system.
DLC
Figure 5-4 Connecting the DLC Using Twisted 2-Pair Cable

Table 5-14 DT300 Series Loop Resistance and Cable Length

Table 5-15 DT700 Series Loop Resistance and Cable Length

term
Table 5-16 D Series i or D
Length
Table 5-17 Cable Connection Between the Analog Port and the Single Line
Equipment

Table 5-18 Cabling Requirements

S
PECIFICATIONS
Series i telephones, single line telephones, cordless
70 on the SV8100 system. The D
Twisted 2-Pair Cable
term
IP Terminal Loop Resistance and Cable
Issue 5.0
term
70 (DTU/
is a diagram of the
RJ-11
Multiline Terminal
5 - 19