Normal Stand-by
No audible or visual indicators.
Fire Alarm
Pulsing audible alarm, the following message will be displayed on the keypad:
This message will be accompanied by other messages related to the alarm. The keypad will scroll through each mes-
sage at a 2-second interval.
To Silence an Alarm, Enter an Access Code
The alarm messages will be displayed until the initiating devices are mechanically reset.
To Reset Smoke Detectors
Enter an Access Code to reset smoke detectors.
Alarm Test
Activate smoke detector or waterflow sensor according to manufacturer's testing instructions.
Bell and Communicator Test
Enter [*][6][Access Code][4] on a system keypad.
Trouble Conditions
Trouble conditions are indicated by:
• The keypad Trouble light will turn ON
• The keypad buzzer will beep
To view trouble conditions:
• Press [*][2]. The keypad display will indicate the trouble.
To silence the trouble beeps:
• Enter a valid access code at any keypad. The Trouble light remains on and you can view trouble messages
using [*][2] until the trouble has been cleared and the affected detectors are reset.
NOTE: In the event of trouble with the Fire Detection section of this system, contact:
Name: ________________________________________________________________________________________________________
Address: ______________________________________________________________________________________________________
______________________________________________________________________________________________________________
______________________________________________________________________________________________________________
Telephone: ____________________________________________________________________________________________________
68
NOTE: This notice is to be framed and mounted adjacent to the
control unit or the keypad at the main entrance.
Fire Alarm Operating Instructions
First Fire Alarm
[Zone Label]
TEST SYSTEM WEEKLY
NOTE: Refer to Instruction Manual for testing instructions.