Table of Contents
Advertisement
Section 1: General Information
3.2.3.4 Bringing the Tape Drive Online
HP StorageWorks DAT 72 (Models 5242 and 5242-ACL) User's Guide
SCSI
Terminator
on Port
Figure 7
Connecting the SCSI cable to the drive
After the 5242 or 5242-ACL tape drive has been installed and the cables attached, bring the
tape drives online. For each tape drive:
1. Verify the AC power cord for the tape drive is plugged into an external power source.
2. Check that the 5242-ACL magazine is not in the drive.
3. Apply power to the tape drive by setting the AC power switch to the ON (|) position. To
power off the tape drive, set the AC power switch to the OFF (0) position. See Figures 8
and 9.
Fan
Connectors
Figure 8
AC power switch on the 5242 tape drive
Blank
Fan
SCSI
Connectors
Figure 9
AC power switch on the 5242-ACL tape drive
Copper
SCSI Cable
to PMF CRU
SCSI Port
Blank
SCSI
AC Out
AC Out
Power
Power
Connector
Connector
Power
Switch
AC Out
Power
Connector
AC In
Power
Connector
11
Power
Switch
AC In
Power
Connector
HP Part Number 528296-03 July 2005
Advertisement
Table of Contents
