Table of Contents
Advertisement
Removing and replacing the system board
Important: When replacing the system board, you must:
v Either update the firmware to the latest level, or restore the pre-existing firmware
v Update the UUID (see "Updating the UUID" on page 26).
v Update the DMI/SMBIOS (see "Updating the DMI/SMBIOS data" on page 26).
Complete the following steps to remove the system board.
Note:
that the customer provides on a diskette or CD.
System board
(5 screws)
Retention module
(4 screws)
v Read "Handling static-sensitive devices" on page 29.
v Read "Safety information" on page 87.
1. Turn off the server and peripheral devices.
2. Disconnect the power cord; then, disconnect all external cables from the
server.
Chapter 5. Removing and installing FRUs (service only)
55
Advertisement
Table of Contents
