Removing And Replacing A Power Supply - IBM 867372X Maintenance And Troubleshooting Manual

4. Remove the cables that surround the power supply and the switch/LED/USB
5. Remove the power supply (see "Removing and replacing a power supply" on
6. Loosen the two screws on the switch/LED/USB card and remove the card.
To install the Switch/LED/USB card, reverse the previous steps.

Removing and replacing a power supply

Complete the following steps to remove the power supply.
Note:
1. Turn off the server and peripheral devices.
2. Disconnect the power cord; then, disconnect all external cables from the server.
3. Remove the server cover.
4. Remove the cables near the power supply.
5. Remove the screws that secure the power supply to the chassis.
6. Lift the power supply away from the chassis.
7. Remove the screws that attach the power-supply connector to the back of the
To install the power supply, reverse the previous steps.
card.
page 57).
Power-supply
Tabs
v Read "Handling static-sensitive devices" on page 29.
v Read "Safety information" on page 87.
server; then, pull the connector out of the chassis.
Chapter 5. Removing and installing FRUs (service only)
57