Server Controls, Leds And Power; Front View - IBM 867372X Maintenance And Troubleshooting Manual

Server Controls, LEDs and power

This section describes the controls and light-emitting diodes (LEDs) and how to turn
the server on and off.

Front view

The following illustration shows the controls and LEDs on the front of the server.
CD-eject button
CD-eject button: Press this button to release a CD from the CD-ROM drive.
CD-ROM drive activity LED: When this LED is lit, it indicates that the CD-ROM
drive is in use.
Diskette drive activity LED: When this LED is lit, it indicates that the diskette drive
is in use.
Diskette-eject button: Press this button to release a diskette from the diskette
drive.
Power-control button: Press this button to turn the server on and off manually.
USB 2 Connector: Connect a USB device to this connector.
USB 1 Connector: Connect a USB device to this connector.
Power-on LED: When this LED is lit, it indicates that the server is turned on.
Reset button: Press this button to reset the server and run the power-on self-test
(POST). You might have to use a pen or the end of a straightened paper clip to
press the button.
Hard disk drive activity LED: When this LED is flashing, it indicates that the
associated hard disk drive is in use.
System-error LED: When this LED is lit, it indicates that a system error has
occurred.
4
xSeries 305 Type 8673: Hardware Maintenance Manual and Troubleshooting Guide
CD-ROM drive Diskette-eject
activity LED button
(green)
Diskette drive
activity LED
(green)
System-error
LED (amber)
Hard disk drive
activity LED (green)
Power-control
button
USB 2 connector
USB 1 connector
Reset
button
Power-on
LED (green)