Table of Contents
Advertisement
To order replacement batteries, call 1-800-772-2227 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM reseller or IBM marketing representative.
Note: After you replace the battery, you must reconfigure your system and reset
Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Complete the following steps to replace the battery.
1. Read "Safety information" on page 87, and follow any special handling and
2. Turn off the server and peripheral devices. Disconnect the power cord and then,
3. Remove the cover. See "Removing the cover" on page 34.
4. Remove the battery:
5. Insert the new battery:
44
xSeries 305 Type 8673: Hardware Maintenance Manual and Troubleshooting Guide
the system date and time.
installation instructions supplied with the replacement battery.
all external cables.
a. Press the battery release tab to release the battery from the socket.
b. Lift the battery out of the socket.
a. Tilt the battery so that you can insert it into the socket.
b. Press down on the battery after you insert it into the socket.
Advertisement
Table of Contents
